Products, Highsolid standard gratings · Gitterroste Helling & Neuhaus
Menu

Additional value

Products

Application areas

Grating Request

Service

About Us

Highsolid standard gratings with standard measurements directly from stock

Neuhaus HighSolid standard gratings are directly available from our stock

We have a large stock of standard sizes and can therefore quickly handle high demand. Additionally required custom-made products (e.g. transition pieces, connections) can be delivered within a few days. The material is hot dip galvanised steel with special tensile strength. It is available in the bearing bar measurements and mesh widths listed below.

All standard gratings have a wraparound edge with a U-profile

The profile edge is on the same level as the bearing bars and cross bars. Even greater torsional resistances can, therefore, be achieved without trip hazards. Grating height = Bearing bar height.

Our HighSolid Standard Programme

The following measurements and mesh widths are directly available from our stock at short notice:

Bearing bar 30/2 - Mesh width 31/31

TS 300 x FS 1,000
TS 500 x FS 1,000
TS 600 x FS 1,000
TS 700 x FS 1,000
TS 800 x FS 1,000
TS 900 x FS 1,000
TS 1,000 x FS *1,000
TS 1,000 x FS 1,200
TS 1,100 x FS 1,000
TS 1,200 x FS 1,000

Bearing bar 30/2 - Mesh width 31/9

TS 500 x FS 1,000
TS 600 x FS 1,000
TS 700 x FS 1,000
TS 800 x FS 1,000
TS 900 x FS 1,000
TS 1,000 x FS 1,200
TS 1,100 x FS 1,000
TS 1,200 x FS 1,000

Bearing bar 25/2 - Mesh width 31/31

TS 500 x FS 1,000
TS 600 x FS 1,000
TS 700 x FS 1,000
TS 800 x FS 1,000
TS 900 x FS 1,000
TS 1,000 x FS *1,000
TS 1,000 x FS 1,200

TS=bearing bar, FS=cross bar all measurements in mm.

Steel grating pads (ungalvanized, without surround) bearing bar 30/2, mesh width 31/31 and 31/9

TS 3000 x FS 1350 mm

*Square single grates should be avoided to prevent confusing the direction of the bearing bars when installing. Deviations are permissible if the square single grates are supported on all sides.

Start
query

+49 (0) 5241 604-70